Alarm Lock Eagle 6000 Especificaciones descargar pdf (Pagina 4)

Dealer Keypad Programming.

To access Dealer Program Mode, connect jumper between

Terminals 3 and 6. Hold down Key

[8]

until all LEDs light. Keypad now functions as follows:

Key [

1]:

Advances character in display

(1-9, 0,

b, C, d, E, and F).

[iI:

Clears display.

Keys

[*]

and

[#]:

Advances display to next section of a multisection location.

Exits Program Mode (with jumper removed from Terminals 3

6).

Note:

Do not remove power while in the Program Mode.

Access feature to be programmed by entering its address (see Keypad Programming Sheet).

A beep will sound, indicating that feature is ready to be programmed. Enter required data

using Key

[1].

If number displayed is wrong, press Key

[2]

to clear display. Use Key

[3]

advance to next digit of a multidigit address. After programming is completed, remove jumper

between Terminals 3 and 6, then press Keys [

and [#] to exit the Program Mode. (Caution:

Pressing

them again

after the LEDs go out

will activate Panic!)

Example:

Program Zones l-6 to Report on Alarm.

Referring to Keypad Programming Sheet, Report on Alarm is at B29, a two-section location.

Circle respective data values for Zones l-6

(1,2,4,8

for section 1; 1,

for section 2) on

programming sheet, part of which is reproduced below. Add up each section to obtain entries

to be programmed

("15"

for section 1: “3” for section 2).

FEATURE ZONE

CLO

CLO/OPN

BY USER

1(2(314

516

OPN

REPORT ON ALARM

B29

B29 B45 B45

mh5-MiIlmmIm

11214

11214l8

Sect. 1

Sect.2

Note: The

programmed entry can be only one character, thus two-digit data totals (such as

"15",

above) must be converted to a single character. From the following conversion chart,

note that “15” is displayed and programmed as an “F”.

Entry Total:

10 11 12 13 14 15

Display:

b C d E

To program data entries obtained (“F” for section 1;

“3” for section

2),

install jumper

between Terminals 3 and 6. Hold down Key

[8]

until all

LEDs

light (Program Mode). Press

Keys [B],

[2],

then Key

[9]

to access location B29 (Report on Alarm). Press Key

[1]

repeatedly

until “F” (entry for section 1) is displayed. Press Key

[3]

to advance display to next section.

Press Key

[1]

repeatedly until “3” (entry for section 2) is displayed.

This completes programming for location B29. Either (a) access another location to continue

programming or (b) remove jumper between Terminals 3 and 6 and press Keys

[*]

and [#] to

exit Program Mode.

1 2 3 4 5 6 7 8 9 ... 14 15

Comentarios a estos manuales

Sin comentarios

Alarm Lock Eagle 6000 Especificaciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alarm Lock Eagle 6000