Alarm Lock PDL5300 Manual de usuario descargar pdf (Pagina 6)

6. Insert secondary side IC lever on spindle and push in

until it engages with the lever catch.

7. Insert control key in secondary side core and turn

clockwise. Do NOT insert tailpiece into secondary side

core.

8. With control key in secondary side core, insert core

fully into lock.

9. Turn key counterclockwise and remove key.

CHANGING AN EXISTING IC CORE

1. Remove the existing primary side IC core by inserting

its control key, then turning the key clockwise and pull-

ing the key to remove the core. Set core aside.

2. Insert Alarm Lock tailpiece with washer into new core.

3. Insert new control key into new core, turn clockwise.

4. Insert new core into lever and turn key counterclock-

wise to lock in position.

5. Remove new control key.

6. Remove the existing secondary side IC core by insert-

ing its control key, then turning the key clockwise and

pulling the key to remove the core. Set core aside.

7. Do NOT insert a tailpiece. Insert new control key into

new core, turn clockwise.

8. Insert new core into lever and turn key counterclock-

wise to lock in position.

9. Remove new control key.

REMOVING THE IC CORE & LEVER

1. Remove the existing primary or secondary IC core by

inserting the control key, then turning the key clockwise

and pulling the key to remove the core.

2. Use a screwdriver to push inside of lever catch to the

side (see Fig. 21). Pull off the IC lever.

PROGRAMMING

Your lock can be programmed (and re-programmed again

and again) to suit your changing requirements. Instead of

distributing metal keys, distribute User Codes -- and delete

them from the lock software (also called firmware) when

needed. To program your PDL5300 lock, see WI1622. To

program your DL5300, see WI1672. To program your

DL5200, see OI345.

TROUBLESHOOTING

Electronic Trouble:

Locks works in reverse.

• Reverse motor wires in connector.

Lock will not accept new codes during programming.

• Disconnect battery connector, hold down any button

until lock resets, then reconnect and start program-

ming again.

Lock drains batteries quickly.

• Check all wires for pinching or cutting. Check for wa-

ter damage. If condition persists, consult factory.

Lock is inoperative.

• Check batteries for proper polarity and check for cut

wires.

Lock produces high pitch steady tone during lock opera-

tion.

• Low battery signal - replace batteries.

Mechanical Trouble:

Lever pulls off.

• Lever catch not fully engaged. Lock is not centered

on door. Door too thick. (See Fig. 7).

Unable to assemble primary side lever.

• Key and tailpiece orientation are incorrect (See Figs.

18 - 20).

FIG. 21: REMOVING THE IC CORE LEVER

LEVER CATCH

FIG. 20: INSTALL INTERCHANGEABLE (IC) CORE

INTERCHANGEABLE

(IC) CORE

INTERCHANGEABLE

(IC) CORE TAILPIECE

FIG. 19: STANDARD AND IC CORE TAILPIECE VARIETIES

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Alarm Lock PDL5300 Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alarm Lock PDL5300