Alarm Lock DL 3000 Guía de usuario descargar pdf (Pagina 53)

Delays door entry after valid User code is entered. Note: For DL3500

and PDL3000, valid entries are 0, 5, 15 & 45 seconds.

A Group 2 User will put door into passage mode (lock is unlocked). A

Group 3 User will take door out of passage. Caution! The

consequences of accidentally selecting this option can cause a

security breach!

A Group 2 User will toggle passage mode (lock is unlocked). Caution!

The consequences of accidentally selecting this option can cause

a security breach!

Daylight Saving Time configuration settings for DL3500 and PDL Series

Locks.

Disable Lock Sounder to enable silent operation.

Door Number must be between 1– 96*.

If the lock is a new lock without a designated door number, the door

number specified in this field will be assigned to the programmed lock.

If used with the AL-DTM Data Transfer Module, this is the Door Number

the AL-DTM will use to identify itself to the lock, insuring that the proper

data inside the AL-DTM2 will be matched to the correct lock.

*Only available numbers are listed. AL-DTM only supports first 48

locks. See page 18 and 21 for more information.

DL3000 Lock Only. The lock will adjust for USA Daylight Saving Time

in the spring and the autumn.

The duration of time the lock refuses to recognize ANY User Codes

after the maximum number of invalid entry attempts (with wrong User

Code) has been reached (valid entries are 1-60 seconds).

The duration in seconds that the lock will remain unlocked after a valid

code has been entered (valid entries are 3, 10 & 15 seconds).

The maximum number of invalid entry attempts (with wrong User Code)

the lock will allow before it goes into lockout mode (where it will refuse

to recognize ANY User Code entry). The lock will shut down for the

period programmed in the Lockout Time in Seconds field which

follows. Valid Attempt entries are 1-9.

If checked, all codes entered must be followed by the a key.

"Programmable Features" Screen (PL Series) - Options tab (Version 3.5.6)

The Features screen is used to program lock options and programmable Features. For version 3.6.0, see page 33.

Appendix A

A 2 digit code which will activate the auxiliary relay if entered before a

valid User Code. You must also select Ambush from the Relay

Function List.

Appendix B

Screen shown is from a PL3000

lock. Screen for DL/PDL series is

similar (though some selections

may be grayed-out and therefore

not available).

If checked, allows Group 3 Users to unlock the door one time only, then

their User Code or proximity card becomes disabled.

For use with the DL/PDL3300 lock. Check Enable Door Ajar

Monitoring to enable this feature. Select the door ajar delay time (in

seconds) from the drop-down list, and check Use Sounder on Door

Ajar to enable an audible warning upon a valid door ajar trip.

1 2 ... 48 49 50 51 52 53 54 55 56

Comentarios a estos manuales

Sin comentarios

Alarm Lock DL 3000 Guía de usuario Pagina 53

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alarm Lock DL 3000