Alarm Lock Trilogy DL3000 Series Manual de instrucciones descargar pdf (Pagina 4)

Supported Products

Data Transfer Module (AL-DTM)

An AL-DTM can be used to transfer Lock Programs (and other data) between DL-Windows and locks. When

computers cannot be transported or when electrical power is not available, the hand-held AL-DTM device acts as

a go-between--it allows the transfer of lock data from the computer (through the AL-DTM) and to the lock, or in

reverse (from the lock through the AL-DTM back to the computer).

Infrared Printer (AL-IR1)

An AL-IR1 printer is used to print Audit Trails and User Code lists without the need for a PC. Its infrared

reader means no cable connection to the lock is needed.

Prox Card Reader/Enroller (AL-PRE)

An AL-PRE is used to quickly enroll multiple ProxCards

and ProxKey

keyfobs into DL-Windows without the

need to manually type User Codes. Use the supplied 9-pin DB9 to DB9 serial cable to connect the AL-PRE to

your computer’s serial COM port. Compatible with most HID ProxCards

and ProxKey

keyfobs (37 bits or

less). For PDL series locks only.

HID

HID CORPORATION

ProxCard

/ ProxKey

Keyfob

Compatible with most HID ProxCards

and ProxKey

keyfobs (37 bits or less).

Note: ProxCard

and ProxKey

are trademarks of the

HID

Corporation.

Double-ended Mini Banana Plug Connector

After you create the program in DL-Windows and transfer the program from your computer to an AL-DTM,

transfer the program from the AL-DTM to the lock(s) via a double-ended mini banana plug.

DB9 to DB9 Serial Cable

Enroll ProxCards quickly into DL-Windows, then transfer this new ProxCard

data from the computer to

the AL-PRE via this 9-pin DB9 to DB9 serial cable. Once the data is in the AL-PRE, you can transfer the

data to the lock via the double-ended mini banana plug (see above), thus avoiding the need to use an AL-

PCI cable for this process.

AL-PCI Cable

An ALARM LOCK AL-PCI cable is required to communicate between your computer’s RS-232 serial com-

munications port (COM 1-4) and the AL-DTM or lock. One end of the AL-PCI cable is designed to be used

on a 9-pin serial Com Port. If your computer has a 25-pin Com Port only, a 25-pin to 9-pin adapter must be

used. The other end of the AL-PCI cable features a 2-pin banana plug connector which is polarity sensitive-

-the TAB (marked “GND”) side must be plugged into the lock’s black (left) terminal.

USB to RS-232 Cable

If your computer does not have a serial COM port (DB-9 male) available, you can plug your AL-

PCI2 cable into a special USB to RS-232 cable. Order part PCI-USB for the USB to RS-232

cable only, or ALPCI2-U for both the USB to RS-232 cable and an AL-PCI2 cable).

1 2 3 4 5 6 7 8 9 ... 35 36

Comentarios a estos manuales

Sin comentarios

Alarm Lock Trilogy DL3000 Series Manual de instrucciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alarm Lock Trilogy DL3000 Series