Alarm Lock Trilogy DL3000 Series Manual de instrucciones descargar pdf (Pagina 8)

USER TYPE USER NUMBER GROUP DEFAULT

ASSOCIATION

MINIMUM PROGRAM

LEVEL (See page 6)

Master Code 1 - M

Installer Codes 2 & 3 none 4

Manager Codes 4 - 6 none 3

Supervisor Codes 7 - 9 none 2

Print Only Codes 10 - 11 none 1

Basic User Codes 12 - 50 none none

Basic User Codes Group 1 51 - 100 1 none

Basic User Codes Group 2 101 - 150 2 none

Basic User Codes Group 3 151 - 200 3 none

Basic User Codes Group 4 201 - 250 4 none

Basic User Codes 251 - 296 none none

Quick Enable User 300 Code 297 none none

Quick PC Access Code 298 none none

AL-DTM Code 299 none none

Service Code 300 none none

Basic User Codes 301-2000 none none

Lock Defaults for PDL3000/3500 & ETPDL

Users added will default to a Group Association and a Program Level Ability as follows:

User 299 is a Non-Pass Code. This is the only code that will initiate data transfer with the AL-DTM.

NOTES:

The Programming Level defines the range of programming tasks

a User is allowed to perform. The higher the Level, the more pro-

gramming tasks the User is allowed (with Master allowing ALL

tasks).

Note: Since the Programming Level is closely associated with

the type of User and their abilities, a User who holds a certain

Programming Level is sometimes referred to by their “User

Type”.

For example, PDL Series locks can hold up to 2000 Users in its

programming memory, and each User is associated with a User

Number (see definition of "User Number" in the previous

"Terminology" section) and therefore a specific Programming

Level, as follows:

Master: Always associated with User number 1. Is always en-

abled and can program all functions. (Abbreviated as

Programming Level = M).

Installer: Always associated with Users 2 and 3. Can program

all functions except changing the Master Code. (Abbreviated

as Programming Level = 4).

Manager: Always associated with Users 4, 5, and 6. Can pro-

gram all functions except functions relating to lock

configuration. (Abbreviated as Programming Level = 3).

Supervisor: Always associated with Users 7, 8 and 9. Can only

program functions relating to day to day operation.

(Abbreviated as Programming Level = 2).

Print Only Users: Always associated with Users 10 & 11.

Restricted to print audit trails only. No other programming

ability allowed. (Abbreviated as Programming Level = 1).

Basic Users: Always associated with User number 12 and

higher (except 297-300). No programming ability allowed.

Programming Levels are hierarchical--higher levels are allowed to

do anything the levels below them can do. For example, if you

are a Manager, you are allowed to do anything that Supervisors,

Print-Only Users and Basic Users can do in addition to those

tasks allowed for Managers (Level 3).

Programming Levels

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comentarios a estos manuales

Sin comentarios

Alarm Lock Trilogy DL3000 Series Manual de instrucciones Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alarm Lock Trilogy DL3000 Series