Alarm Lock Trilogy DL3500 Manual de instrucciones descargar pdf (Pagina 29)

ACCESS = Entry into a restricted area.

AMBUSH = An AMBUSH CODE used before a USER CODE and programmed for Relay Ambush can be used to alert security or trip a silent-alarm

on a Burglary Control Panel.

AUDIT TRAIL = A log of previously date/time stamped events that have occurred.

BURGLARY CONTROL PANEL = Provides local alarm and remote communication to request security for burglary/break-in. A DL3500 relay output

used for Ambush can provide a silent-alarm and call-for-help.

CLOCK

• REAL TIME CLOCK = An accurate built-in clock that allows date/time stamping of events. The clock can be slowed or speeded up to fine tune

long term accuracy of the clock to within three minutes per year.

• CLOCK SETTINGS = Printout includes date, time, weekday, and clock speed.

• CLOCK SPEED = The clock can be adjusted to allow faster/slower speeds and therefore increasing clock accuracy.

CODE = Numeric sequence of numbers (such as: 123). If Star-Enter-Key is required, must be followed by a [*] key.

• AMBUSH CODE = A predefined two-digit AMBUSH CODE entered before a USER CODE, with RELAY AMBUSH ACTIVATED. Causing the

door to unlock and cause the relay to momentarily close for a Security Team to respond or a Burglary Control Panel can send a Silent-Alarm

requesting security response through remote communication.

• BASIC USER CODE = User Code used by User 12-296. (Does not allow programming)

• INSTALLER CODE = User Code used by User 2-3. (Allows all programming except master functions)

• INVALID CODE = A code that has not been programmed in the lock.

• MANAGER CODE = User Code used by User 4-6. (Allows most of the programming functions)

• MASTER CODE = User Code used by User 1. Default code is 123456. Master Code has complete control of the lock.

• PRINT ONLY USER CODE = User Code used by User 10-11. (Allows no programming except print functions)

• QUICK ENABLE USER 300 CODE = User code 297 used to Re-enable Service Code User Code 300.

• QUICK PC ACCESS CODE = Permits upload/download to DL-Windows Software on IBM/compatible computer running Microsoft Windows 95,

98, or NT 4.0.

• SERVICE CODE = User 300. Allows only one entry, then needs to be re-enabled by another code to regain access again.

• SUPERVISOR CODE = User Code for User 7 to 9. Can only program day-to-day operation, no default group association.

• USER CODE = Code used by Users. Code is 3 to 6 numeric digits long, allowing controlled entry through door.

• VALID CODE = An entered code that has been programmed in the unit.

COM PORT = A computer serial communications port used to communicate with the Lock and/or Data Transfer Module.

DATA TRANSFER MODULE = A device that permits transfer of program/data between a computer and up to 48 locks.

DATE = Month, Day and Year entered as MMDDYY.

DAY OF WEEK = Sunday through Saturday (where 1 = Sunday and 7 = Saturday).

DISABLE = Turn off.

DL-Windows = Computer software used to communicate with the Lock and/or Data Transfer Module.

DOOR NUMBER = Identification of each door with a specific number (1-48). (Used with AL-DTM Transfer Module)

ENABLE = Turn on.

EVENTS = Recorded lock activity.

1 2 ... 24 25 26 27 28 29 30 31 32

Sin comentarios

Alarm Lock Trilogy DL3500 Manual de instrucciones Pagina 29