Alarm Lock Trilogy DL3500 Manual de instrucciones descargar pdf (Pagina 6)

Wiring

Red / Black (Operation without Batteries) - Optional

External 7.5 VDC Power Source must be used for operation

without batteries.

White / White (Remote Input) - Wire a Normally Open

Contact to wires (white and white). Momentarily close to allow

person to pass through door. NOTE: Remote Input is

enabled from the factory.

Relay: COM-Blue / NO-Yellow / NC-Green - See Function

67 for programming options for the Relay.

Self Diagnostic Indications

Various system tests are performed at power up and during

operation of the lock.

Steady 4 Second Sounder with a Yellow LED indication

every time a user code is entered - indicates a Low

Battery Condition.

Continuous Series of Beeps - indicates the lock detected

a system fault which would not allow any part of the system

to operate. Ensure batteries are good.

Sequence of 7 Beeps Repeated 4 Times with a Yellow

LED indication, every time a user code is entered -

indicates a non-fatal memory or clock error has been

detected. Under this condition, unexpected operation is

possible. Do not mistake the low battery indication as a

memory or clock error.

Wiring to Disarm a Burglary Control Panel

See illustration on connecting the DL3500 to an Alarm Panel.

Scheduled Relay Activation - Group 1 Activated

(Function 90/91) on on page 23.

The Three Methods of Powering Up are:

• Battery Replacement

• Power-Up Retain Lock Programming

• Power-Up Erase All Programming

Battery Replacement

When a valid code is entered and the batteries are weak the

lock LED will display a yellow color, and the sounder will

sound for 4 seconds. The DL3500 uses 5 AA-size 1.5 volt

alkaline batteries. The lock will function with weak batteries;

however be sure to replace the batteries as soon as

possible.

Remove the screw at the bottom of the housing and remove

the cover. Pull out the battery pack and replace all 5

batteries quickly - within 1 minute. Note: Do not press any

buttons while replacing the batteries (unless lock

programming is to be erased). Pressing any key will remove

the voltage that is required to keep the system clock.

Power-Up - Retain Lock Programming

(Clock Settings lost)

1. Disconnect battery pack connector.

2. Press any key to insure the locks capacitor is fully

discharged.

3. Re-install battery pack (lock will give 3 short beeps).

4. Do not press any keys for 10 seconds.

5. After the 15 second period the LED will flash red 6 times

and 6 beeps will sound.

The lock is now ready for use. Program is loaded from non-

volatile memory. Set the clock using functions 38, 39 and 40.

Power-Up - Erase All Programming

(Factory Default will be loaded)

1. Remove the battery pack.

2. Press any key to insure locks capacitor is fully discharged.

3. Re-install the battery pack (lock will give 3 short beeps).

4. Press any key within 5 sec after hearing the 3 beeps.

5. A series of 5 RED LED and 5 beeps will be heard

followed by 10 seconds of silence, 3 GREEN LED and 3

fast beeps.

All programming has been erased and the lock is now ready

for use.

Note: All lock programming can also be erased by entering

Function 99.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comentarios a estos manuales

Sin comentarios

Alarm Lock Trilogy DL3500 Manual de instrucciones Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alarm Lock Trilogy DL3500