Alarm Lock ETPDLN Manual de instrucciones descargar pdf (Pagina 4)

AL-IM80211

AL-IME

AL-IMEPOE

Supported Products

AL-IM SERIES WI-FI Gateway Module

Each lock contains a radio that transmits and receives--via a private wireless signal--to an

intermediate device called a Gateway module. In turn, this Interface Module is connected

(either wirelessly or wired) to a computer network such as a LAN or corporate Intranet. A

Windows PC connected to this network can control and program all locks by the use of the DL-

Window software (see OI237). With access rights to the software, one computer--or several--

can control the software and consequently can control the locks in the system. Several

Gateway device models are available; all have the two antennas used to transmit to the locks

via an Alarm Lock proprietary radio connection.

● Gateway "Wireless/Wired" AL-IM80211 - Hardwired/Wireless Gateway Interface Module.

Supplied with its own Class 2 transformer to supply power; connection to a network is

supported via either a wired connection (using a standard RJ-45 Ethernet cable) or a

wireless connection (using a third antenna for 802.11 transmissions). Ensure adequate

802.11 coverage in the area where the "Wireless/Wired" Gateway is mounted. Supports up

to 63 Networx Locks. Ceiling- or wall-mountable.

● Gateway "Wired" AL-IME - Hardwired Gateway Interface Module, supports up to 63

Networx Locks, connects directly to a network using a standard RJ-45 Ethernet cable.

Ceiling- or wall-mountable; powered with Class 2, 6VAC transformer (supplied).

● Gateway "Power over Ethernet" AL-IMEPOE - Hardwired Gateway Interface Module +

POE (Power Over Ethernet), supports up to 63 Networx Locks, connects directly to a

network using a standard RJ-45 Ethernet cable and POE. Ceiling- or wall-mountable.

● Gateway "Plenum Rated POE" AL-IMEPOEP - Same as above "AL-IMEPOE", with

added enclosure protections and installation hardware for mounting above "drop-ceiling"

tiles or other locations subject to air pressure changes (HVAC air-filled spaces, etc.).

Proximity Card Reader/Enroller (AL-PRE)

An AL-PRE is used to quickly enroll multiple proximity cards and keyfobs into DL-Windows

without the need to manually type User Codes. Use the supplied 9-pin DB9 to DB9 serial cable

(see below for description) to connect the AL-PRE to your computer’s serial COM port. Com-

patible with most HID ProxCards

and ProxKey

keyfobs (37 bits or less). For PDL series locks

only.

ProxCard

/ ProxKey

Keyfob

Compatible with most HID ProxCards

and ProxKey

keyfobs (37 bits or less).

Note: ProxCard

and ProxKey

are trademarks of the HID

Corporation.

HID

HID CORPORATION

DB9 to DB9 Serial Cable

Enroll proximity cards and keyfobs quickly by using the AL-PRE to DL-Windows by connecting

one end of this 9-pin male DB9 to female DB9 serial cable to the AL-PRE and the other end to

your computer’s serial COM port. If your computer does not have a serial COM port (DB-9

male) available, use the USB to RS-232 Cable described below.

USB to RS-232 Cable

If your computer does not have a serial COM port (DB-9 male) available, you can plug your AL-

PCI2 cable into a special USB to RS-232 cable. Order part MX1130 for the USB to RS-232 cable

only.

1 2 3 4 5 6 7 8 9 ... 35 36

Comentarios a estos manuales

Sin comentarios

Alarm Lock ETPDLN Manual de instrucciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alarm Lock ETPDLN