Alarm Lock ETPDLN Manual de instrucciones descargar pdf (Pagina 5)

Lock Design Overview

Why Use Software inside a Lock?

With ordinary door locks, the need to make physical copies of metal keys and distributing them can be a huge organizational and

financial task -- and what will you do if someone causes a security breach by losing their key?

The answer lies in the advantage of SOFTWARE. Software (also called "firmware") is not "hard" or "fixed" like hardware is. Soft-

ware is "soft" -- flexible and changeable to your needs. Software exists inside your Alarm Lock™ series lock, and can be pro-

grammed (and re-programmed again and again) to suit your changing requirements. No more metal keys to distribute...instead,

distribute User Codes -- and delete them from the software when needed. (A User Code is the software equivalent of a metal key-

-it is a series of numbers the User enters into the lock keypad to unlock the lock).

Preparing to Program your Lock

The keypad contains 12 buttons, numbers 1 through 9 plus zero, a star button (:) and a special "AL" button (;). These 12

keypad buttons are all you need to program your lock. In addition to manually programming your lock using the keypad, you can

also program your lock using a computer program called DL-Windows. DL-Windows is not needed--but it makes programming

faster and easier. In addition, the PDL6500 and ETPDLN locks are designed to allow all features to be programmed either at the

keypad or through its radio link to a DL-Windows equipped computer. This guide will show you how to program your lock using

the keypad, without DL-Windows. (For more information about DL-Windows, see User Guide OI237 and OI352).

Programming your lock begins after you unpack it from the box -- there is a specific procedure outlined in "Quick Start" (page 11)

in which you "wake up" the lock to prepare it for programming. This "Quick Start" procedure shows you all the steps required to

get your lock to start working. To begin programming, you must first enter something called "Program Mode".

What is Program Mode?

The software has only two "modes"--"Normal Mode" and "Program Mode". When you want to make changes to the lock program,

you enter "Program Mode". When you finish programming and wish to put the lock into use, you exit "Program Mode" to enter

"Normal Mode".

You can enter Program Mode using the keypad by pressing the Master Code of the lock that was set at the factory. The Master

Code is basically a secret "passcode" that allows you to enter Program Mode. But since all locks are identical and leave the fac-

tory with the same Master Code, this factory Master Code is therefore not very secret--and should be changed to your own per-

sonal Master Code. This way, only YOU can enter Program Mode and make changes to the lock programming.

Once the new Master Code is set , then you can continue with the Quick Start procedure and set the weekday, date and time. Af-

ter this, you can start entering User Codes for people to use. All changes to the lock are organized by their Function Number.

Want to change the date? Use Function Number 38. Want to add a User Code? Use Function Number 2. There are 99 Func-

tions in total, some that you will use often, and others that you may never need.

Notice that when you program your lock, programming tends to follow a

consistent 5-step pattern: (1) Enter Program Mode

(2) Press ; followed by the Function # (3) Press ; and enter data (4) Press : to end (5) Exit Program Mode to

put the lock into use.

Turn the page and learn about the special terminology used with your lock. Once that is clear, use the Quick Start proce-

dure on page 11 to help you get up and running.

Green LED

Red LED

Proximity Reader

Special "AL" (;) Key

"STAR" (:) Key

1 2 3 4 5 6 7 8 9 10 ... 35 36

Sin comentarios

Alarm Lock ETPDLN Manual de instrucciones Pagina 5