
XARTU/5™ Manual Copyright© 2013
Eagle Research Corporation
®
REV 11.1.11 Page | 28
The RTU can be configured to monitor and alarm on any condition including, but not
limited to, the following:
First Time Power
AC Power Failure
Low Supply Volts
High and Low Flow Rate
High and Low Pressure
High and Low Differential Pressure
High and Low Temperature
Current Day Flow (Transportation Limit)
Low Voltage Shutdown
Box intrusion
Liquid levels
Valve status
Viewing and Clearing Alarms from the keypad
To enter alarm mode, press the alrm key. In alarm mode, you can view and
acknowledge any alarm. If alarms are active, the unit will display the first alarm
message. If there are more alarms, you can view them by pressing the key.
Repeatedly pressing the key cycles through the active alarm list.
Alarms can be locally acknowledged at the RTU by pressing the ent key while a
particular alarm message is displayed or by polling with Talon software.
Unless the parameter's limits are violated again, the unit will not include acknowledged
alarms in its list the next time the user enters alarm mode. To exit alarm mode without
acknowledging the alarm, simply press the esc key.
CONFIGURATION MODE
To enter configuration mode, press the conf key. If the configuration mode is
password protected, the RTU will display ENTER PASSWORD?. Only a valid password
entry would then be given access to this mode. Configuration mode allows you to set
up the RTU's initial configuration, change any of the operating parameter values, set
alarm conditions and limits, or assign function keys to a parameter. While in the
configuration mode, the RTU continues to operate normally; it continues to sample live
pressure and temperature values, calculate corrected volume, and collect historical
data.
NOTE
Additional hardware equipment and configuration may be required for some alarm monitoring.
Comentarios a estos manuales