Alarm Lock ETPLN Guía de usuario descargar pdf (Pagina 25)

DL-WINDOWS™ for Trilogy Networx™ V4.0 USER'S GUIDE 25

Normal Tasks (cont'd)

"discovering the Gateway(s)" action, and the "adding

the Gateway(s) to the current Account" action.

Now that the new Gateway is added to the Account

in DL-Windows, you can use this new Gateway to

discover locks that have been (or will be) physically

installed on doors.

Resetting the Gateway

"Resetting" the Gateway clears all memory and ensures

that any residual voltage or test data existing from the

factory is cleared from the unit. Always reset the Gate-

way for new installations; you can also reset the Gate-

way anytime after the Gateway is powered. Two levels

of reset exist, a "Partial" reset and "Full" reset, as fol-

lows:

"Partial Reset" clears the Gateway's "Lock Config Ta-

ble"; but if the Gateway was previously programmed for

wireless network communication, this reset leaves the

Gateway in this "wireless" condition. With power applied

to the Gateway, press and hold the "RESET" button and

the red light turns on continuously; continue to hold the

button and the red light will start to flicker. Release the

button and the red light will continue to flicker. The

Gateway is now "Partially Reset".

"Full Reset" returns the Gateway to its factory condition,

clearing the Gateway's "Lock Config Table" and resets

the network selections to its factory default "wired" con-

dition. Continuing from the "Partial Reset" instructions

above, with the red light flickering without any buttons

being pressed...

...With the red light flickering, press and hold the

"RESET" button again and the red light turns on continu-

ously...continue to hold the button and the red light will

start to flicker...continue to hold the button until the red

light turns on continuously...then release the button and

the red light turns off...after a few seconds the red light

will then start to flicker. The Gateway is now "Fully Re-

set".

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

Sin comentarios

Alarm Lock ETPLN Guía de usuario Pagina 25